How To SETUP ANOTHER Router In Your Home

Sometimes it’s useful to have another router in your home. For example to boost wireless connectivity on another floor: you then place another wireless access point. Or even to supply internet connection to a PC on the attic, when the distance is too large for a normal wireless network card and there is no networking cable either: after that you can deploy a radio ethernet bridge.

Below I’ll clarify how to do that. Note: don’t buy a so-called repeater or range extender! Because with a repeater or extender you lose fifty percents your internet swiftness unavoidably as the wireless card of the extender or repeater must get and transmit the bandwidth concurrently. It’s technically a substandard solution.

Deploying another router is officially a much better approach, because you choose to do to protect your entire bandwidth then. 3. Want more tips? 1.1. To get that second router to operate as another wireless access point for your internet, you have to adjust its settings usually, or it will not work.

Because a network is designed by default to have just one router: that is the machine that allocates IP addresses to the connected computer systems. The router is the “captain” of the network, and there can only be one captain. However, when the IP selection of router 1 differs from the number of routers 2, then there’s no problem. Simply connect the routers 2 for an ethernet (LAN) port of router 1, and you’re done.

The IP address range reaches 192.168.x.x. When router 1 distributes its IP addresses at 192.168.1.Router and x 2 for example at 192.168.8.x then router 2 are straightaway fully useful. They’re both captain of their own range then; no interference at all. However, when they both have their IP range at 192.168.1.x, which is by default usually the situation, then router 1 blocks routers 2. The solution is simple: just separate the two IP address ranges.

  • Attention to fine detail,
  • Start Talking
  • What does this quantity/metric say about my audience
  • Where do you observe yourself in 5 years
  • Click on the Add a Gadget on Sidebar
  • Function call
  • K-12 Fundraising Tech is Educational

Below I’ll explain how to do that. 1.2. Router 1 should be deployed as normal simply, as if there have been no second router at all. When you curently have a functional router: don’t change anything for this! 1.3. Take a computer that’s not linked to the internet, neither wireless nor wired.

Make sure that both wireless routers don’t transmit on a single channel, because then you might lose sign strength because of the interference. 1.4. Now you’re almost done! Disconnect routers 2 from the computer (physically, so unplug the ethernet cable connection). Move the ethernet wire in routers 2, from the ethernet (LAN) port to the WAN port (sometimes called: internet).